COOL SUPER ELASTIK a adhesive for polystyrene, Styrodur, stone wool, and reinforcement.

GENERAL INFORMATION AND PURPOSE

COOL SUPER ELASTIK adhesive is made based on polymers, cement, and special additives for bonding and reinforcing thermal insulation boards made of: polystyrene, Styrodur, stone wool on mineral substrates.
Substrate preparation: Substrates made of concrete at least 2 months old, brick, mortar, aerated concrete, asbestos-cement, etc., must be flat, solid, dry, clean, and free from frost.
Mixing the compound: Mix the contents of a 25 kg bag with approximately 6 – 6.5 liters of water, by hand or with an electric mixer, until the mixture becomes homogeneous. Let the mixture rest for about 10 minutes and mix again.

INSTRUCTIONS FOR USE

COOL SUPER ELASTIK adhesive should be applied in strips along the edges of the board and in spots (3-5 spots) in the center, then press the board onto the prepared substrate with an overlap of 10 mm. It is recommended to use dowels for polystyrene boards, with a minimum of 6 dowels per square meter. The covered surface of the board with adhesive must be greater than 40%.
Application: On the glued boards (after 2 days), apply COOL SUPER ELASTIK adhesive using a metal trowel in a thickness of 2-3 mm with an overlap of 10 mm. Allow the layer to dry for 48 hours (under normal conditions), then finish with a decorative plaster. The total thickness of the applied adhesive film should not exceed 4 mm. The optimal working temperature is between +5°C and +30°C.

CONSUMPTION

Adhesive application: Polystyrene 3.0-4.0 kg/m²; 4-5 kg/m² for EPS; 6-7 kg/m² for MV and reinforcement.

PACKAGING

25 kg

SHELF LIFE AND STORAGE

The content of soluble Cr (VI) in the product is less than 0.0002% within the shelf life and storage conditions specified by the manufacturer. At least 12 months in factory-sealed packaging, in dry and ventilated rooms at a temperature of +5 to +30°C.