Cool Super elastic adhesive

An adhesive for bonding and reinforcement of thermal insulation boards of: styrofoam, styrodur, stone wool on mineral substrates. It is made on the basis of polymers, cements and special additives.


Substrate preparation: minimum 2-month-old concrete substrate, bricks, extended mortar, aerated concrete, corrugated boards, etc., must be flat, firm, dry, clean and not frozen. Compound preparation: Mix the contents of a 25 kg bag with approximately 6 – 6.5 liters of water, manually or by electric mixer until the compound becomes homogeneous. Allow to restfor about 10 minutes and stir again. Application method: Adhesion: Apply straps ofthe COOL SUPER ELASTIC adhesive along the board edges and spots (3-5) along the middle, then press the board onto the prepared substrate with a 10 mm overlap. The recommended anchoring of styrofoamboardsis, as a rule, at least 6 anchors per m². The board surface covered with the adhesive must be above 40%. Processing: Applythe COOL SUPER ELASTIC adhesive on glued boards(after 2 days) with a metal trowel in a thickness of 2 – 3 mm with an overlap of 10 mm. Allow the layer to set for 48 hours (under normal conditions) and then finish with a decorative mortar. A total film thickness of applied adhesive is up to 4 mm. The optimum operating temperature is from +5 to +30°C.

Shelf life:

12 months from the date of manufacture in the factory sealed packaging, in dry and ventilated premises at a temperature between +5°C and + 30°C.


Adhesion: Styrofoam 3 – 4 kg/m²; from 4 – 5 kg/m² EPS ; from 6 – 7 kg/m² for MV and reinforcement.

Packaging units:

25 kg